Wilsonart laminate flooring is a nice flooring option since it is easy to install, affordable, stain-resistant, and also durable. It is really easy to install laminate flooring inside your house. For 12 x 10-foot room, we’ll only spend about four hours to laminate the floor. We have some tips that will help you covering your floor with laminate flooring successfully. First tip is prying up shoe molding. Remove the quarter round shoe molding that’s running along baseboard, but you must leave baseboard molding in its place.
Pry up shoe molding on the baseboard using thin pry bar, do this carefully. Try not to damage the shoe molding because you will need to replace it as soon as you finish installing the Wilsonart laminate flooring. When you’re installing the shoe molding back into the place, you must make sure that you nail it properly to its baseboard instead of nailing it to your flooring. Now, continue the step by undercutting the casing.
Make sure that your new Wilsonart laminate flooring fits neatly around your doorways by undercutting your door casings also the jambs in order to make the flooring slips underneath. Place a piece of underlayment that’s made of rubber right in front of casing. Next, set scrap piece of the Wilsonart laminate flooring cherry rose over it. Use some stools like handsaw, saw, and other else in order to help you cutting flush across the top of your flooring scrap also through your casing. After all, you must clean the entire debris and dust.
Prepare the subfloor before you start installing Wilsonart laminate flooring. To prepare the underlayment on the subfloor, you need to tap down the nail heads that will protrude from your floor surface. Then, you must step around your room to check if there are any squeaks on the floor. If there are squeaks on the Wilsonart laminate flooring golden oak, you need to drive a drywall screw in 2-inch size to the squeaks on your subfloor. For more effective way in stopping the squeaks, drive screws into the joists.wilsonart laminate floors